Calculate filament cost from the net spool weight
Divide what you paid for the spool by the net filament mass, then multiply by the grams your slicer expects to use. The net weight is the plastic on the spool, which excludes the empty reel or packaging. For a USD 24 spool with 750 g of plastic, material costs USD 0.032 per gram or USD 32 per kilogram. An ordinary part that uses 60 g of that spool consumes USD 1.92 before any machine time or labor.
Use the weight for the entire plate when you print several parts at once. If a four-part plate uses 120 g including supports and purge, it consumes USD 3.84 at USD 32/kg. Dividing that plate cost by four gives USD 0.96 per piece at full yield. Shared purge and support material are included once for the run.
Check what the slicer counted
A slicer can report a combined total for the plate or break out model, support, and purge by extruder. Use the combined value if it covers every material consumed. When your figure covers model material only, clear the inclusion checkbox and enter the additional support and purge grams per run. A single rate works when the same material price applies throughout. For distinct rates, calculate each material separately and add the results.
An order of ten parts with four usable pieces per run needs three planned runs. The order estimate charges the input weight for all three. If you re-slice a smaller final plate at a lower weight, calculate that plate separately. The full-yield cost per piece and the average material cost per ordered piece can differ because of that last run.
Add the remaining print costs
After you calculate the material estimate, send the quantities, grams per run and price per kilogram to the 3D print pricing calculator. The transfer uses temporary browser session storage and is read once. Enter print time, electricity, labor, failure allowance and selling fees to find a quote subtotal. When you already know your unit selling price, create a customer quote directly.
Frequently asked questions
How much does a gram of filament cost?
Divide the spool price by its net filament weight in grams. A USD 24 spool with 750 g of printable material costs USD 0.032 per gram.
Should I add support and purge weight?
Add support and purge once when the slicer weight does not already include them. Use the total for the whole plate, including all the pieces on that plate.
Why can total material cost exceed price per piece times the order quantity?
The order charges enough full-cost runs to make the requested number of pieces. A partial final plate can cost less if you re-slice it and price that run separately.